Tiwica
Hi everyone,

because pictures tell more than words, I post the progress in pictures.
Perhaps you can tell me, what I have done wrong or understand wrong?
Thanks for help.

Tiwica


1.jpg  2.jpg  3.jpg  4.jpg  5.jpg  6.jpg  7.jpg  8.jpg  9.jpg  10.jpg 
There is no island, just a flat ground under the water.
0 0
voxelfarmtorres
It looks like you may be missing the hints displayed in the top area of the wizard:

"Choose a folder where to create the new project files"

"Choose  the wind direction for each corner of the map"

"Provide a temperature value (in Celsius) for each corner of the map"

8Km above sea level.

500 Km along one dimension of the map.

At the end you may land in the middle of the ocean, click on "Render > Find Land"
0 0
Tiwica

"500 Km along one dimension of the map."
This can't be right. When I enter 50 this island is created. And it doesn't look like a 50x50km island, more like 7x7km


11.jpg 
0 0
voxelfarmtorres
If you set maximum altitude to 8Km, this image looks correct. Note the entire map is 50Km wide, including the ocean. Landmass will be 1/2 of that maximum. So you have a 20Km base for your 8Km mountain. This is like fitting mount Everest in a 20Km by 20Km base.
0 0
ashkan.saeedi.1989
@voxelfarmtrres do you mean it looks to be smaller or you mean the land will really be smaller because of bad ratio of width and highest altitude
0 0
voxelfarmtorres
My comment was that the actual land portion on a 50Km map will be much smaller than 50Km. When you place such a high mountain range over such a small landmass, the bad ratio between height and base makes the whole landmass appear weird.
0 0